Venetian Blinds Installation Guide
Check your ‘Measure’ sheet to determine the configuration of the blind.
You need to determine what type of surface you are mounting your bracket to. Predrill using the brackets as a guide. Ensure you use appropriate plugs and masonry tools if mounting into brick or stone. It’s best to install brackets on studs if possible.
Secure brackets with one screw only. Once satisfied with position proceed to secure brackets in place using the second screw. Make sure to mount brackets where they will not interfere with venetian mechanisms.
When inserting the headrail into the brackets, hook the front of the headrail to the front of the bracket (spring-loaded side). Once the front is in, rotate and push toward the glass so the rear of the headrail clips into the rear hooks of the bracket.
Hook the front end in Rotate the headrail into position
- TIMBER – We recommend predrilling holes and using 25mm button head screws
- PLASTER – We recommend a wall anchor.
- STONE, CONCRETE, BRICK, TILE – Use a masonry drill with appropriate screws, anchors and plugs
A child safety clip must be installed if the cord sits lower than 1.6 metres from the floor.
The blind must be installed so that the loose cord cannot form a loop 220mm or longer at a height of less than 1.6m above the floor.
Position the clip against the window frame inaccessible to small children. Screw the clip into the architrave or window frame.
We here at Onlineblinds4u take the safety of our kids very seriously.
WARNING: Young children have died by wrapping loose curtain and, blind cords or chains around their necks. Secure cords or chains with cord guides or keep them out of reach by winding them around a cleat. Move cots and furniture away from window covering cords or chains.
Do not remove this label.