Vertical Blinds Installation Guide
Check your ‘Measure’ sheet to determine the configuration of the blind.
You need to determine what type of surface you are mounting your bracket to. Predrill using the brackets as a guide. Ensure you use appropriate plugs and masonry tools if mounting into brick or stone. It’s best to install brackets on studs if possible.
Screw the clip into the bracket, ensuring clips face the same direction. Push the lip of the track in and then rotate the other into place.
Screw the clip into the recess, ensuring the clips face the same direction. Push the lip of the track in and then rotate the other into place.Simply feed the slat into the runners, lean on a slight angle and the slat will sit inside the hook. And then hang the wand if ordered.
Simply feed slat into the runners, lean on a slight angle, and the slat will sit inside the hook.
And then hang the wand if ordered.
- TIMBER – We recommend predrilling holes and using 25mm button head screws
- PLASTER – We recommend a wall anchor.
- STONE, CONCRETE, BRICK, TILE – Use a masonry drill with appropriate screws, anchors and plugs
There needs to be a maximum of 300mm between brackets to ensure the strength of the blind.
Secure brackets with one screw only. Once satisfied with the position, proceed to secure brackets in place using the second screw.
Make sure to mount brackets where they will not interfere with vertical mechanisms.
A child safety clip must be installed if the chain sits lower than 1.6 metres from the floor.
Fit the chain into the loop of the clip. Pull the clip down until it is as tight as possible without placing tension on the chain. Screw into place.
WARNING: Young children have died by wrapping loose curtain and blind cords or chains around their necks.
Secure cords or chains with cord guides or keep them out of reach by winding them around a cleat.
Move cots and furniture away from window covering cords or chains.
Do not remove this label.
We here at Onlineblinds4u take the safety of our kids very seriously.